Cleaning & Restoration Association News

Particulates in Restoration Situations: Hazards and Solutions

I recently received a call on a subject that is of increasing concern in the fire-restoration work place.

As I understand it, a restoration contractor was concerned about removing particle contaminants on fire losses to prevent their progressive release into respirable air over time, along with a potential for adverse health effects for occupants and workers who may have prolonged exposure.

The fire cycle (combustible components, oxygen, ignition source) produces hundreds of chemicals in a damaged home or business. Typically, these combustion pollutants fall into two broad categories: oxides of nitrogen from burning organic components, and chlorine dioxide from burning synthetics. Also contained in most combustion soot are polycyclic aromatic hydrocarbons (PAH), which are suspect carcinogens. Therefore, it stands to reason that proper restoration of smoke-damaged structural materials and contents is of significant importance.

According to the Stanford Research Institute, combustion particulates range in size from 0.1 to 4 microns. By way of comparison, an average human hair is about 75 microns in diameter. To lend perspective to the importance of physical smoke removal, while particles 1 micron to 4 microns in size settle out of air in a matter of minutes or hours, anything smaller than 1 micron may remain suspended in respirable air indefinitely.

Human bronchial passages contain ciliated surfaces designed to capture particles in the 10-micron range and above, and push them back into the throat where they are swallowed and eliminated through the digestive system. Anything smaller can penetrate deep into tender lung tissues where they encounter the alveoli. The alveoli are small sacks that remove oxygen from air in the lungs and transfer it into the bloodstream to oxygenate muscles and organs. At best, smoke particles smaller than 10 microns can irritate the alveoli; at worst, they may cause permanent scaring and diminished lung capacity, depending on the amount respired.

With the above considerations in mind, there are several recommended phases for resolving fire contamination and corresponding potential health effects:

Ventilation - The first phase begins with airing out the structure with positive ventilation, assuming reasonable weather conditions (i.e., heat, cold, humidity) in the geographical area. Obviously, extremes of heat and particularly cold, present occupant comfort limitations in occupied structures, and certainly freezing weather can damage water-bearing appliances or plumbing. Excess humidity from outside, when combined with combustion smoke, only accelerates the formation of acid residues, and extremes of heat and cold have an adverse impact on occupants and workers.

Isolation - Where a building has experienced a partial fire loss, it may be prudent to initiate OSHA-mandated engineering controls, such as isolation barriers or even containment with polyethylene sheeting where appropriate.

Air Management - Another engineering control on partial losses may involve controlled air management in much the same manner as would be appropriate during mold or sewage remediation (fungal or bacterial contamination). Of course, this assumes that the building can be contained and doesn't have gaping holes in the roof or burned-out windows or doors.

PPE - Once OSHA-mandated engineering controls are in place, where possible, the second line of defense against particle contaminants is personal protective equipment (PPE). This may include chemical-resistant gloves, goggles, respirators and even protective clothing. The protection afforded by N-95 respirators is marginal, especially where 0.1-micron to 4-micron particles are concerned (ref. Appendix B, IICRC S520); therefore, I specifically recommend tight-fitting face pieces with HEPA filters worn by medically evaluated and fit-tested persons, at a minimum.

HEPA Filtration - High-efficiency particulate air (HEPA) filters on air filtration equipment is appropriate during fire restoration to capture 99.97 percent of particles at 0.3 microns. This equipment may be set up initially in areas where extensive or prolonged work (e.g., pack out), or demolition is on-going.

HEPA Vacuuming - While ventilation or HEPA filtration may help in removing particulates from the air, HEPA vacuuming prior to detergent cleaning is appropriate to capture and remove fine particles from surfaces before they can be suspended in respirable air. HEPA vacuuming also removes fine particles from cracks and crevices where it may not be possible to reach them with wet cleaning. It is particularly important to attend to the interior surfaces of HVAC ductwork and mechanical components, which will be circulating respirable air on a continuing basis.

HAZMAT Abatement - In older homes where demolition of fire-damaged structural components is necessary and where hazardous materials, such as lead or asbestos, are present, following the implementation of engineering controls, including containment and positive air management, protected abatement workers usually are required to use adequate wetting during demolition followed by HEPA vacuum cleaning techniques. Unless properly trained, certified and licensed in HAZMAT abatement and disposal, it may be best to hire subcontract personnel to perform this important task.

Cleaning - Detergent wiping, while not an efficient method for removing particulates, aids in restoring surfaces to a visually acceptable pre-loss condition, where possible.

I hope this helps to shed some light on the question on fire particle contamination that restoration contractors raise. Certainly, if you have further questions, I would be glad to address them as possible.

Did you enjoy this article? Click here to subscribe to i Cleaning Specialist Magazine.

Recent Articles by Jeff Bishop

You must login or register in order to post a comment.



Image Galleries

The 2014 Experience Conference and Exhibition

A look in photos at the 2014 Experience Conference and Exhibition, which was held from April 24-26 at the Embassy Suites Convention Center and Spa in Frisco, Texas.


Beginning April 21, Google will start judging websites based on their mobile friendliness. What exactly does this mean to you cleaning website? Find out in the latest edition of The Hitman Advertising Show, which will also cover tips and suggestions on getting mobile compliant.
More Podcasts

ICS Cleaning Specialist Magazine


2015 April

The April ICS issue features content on concrete polishing, green cleaning, air duct cleaning, injection sprayers and new products.

Table Of Contents Subscribe

Janitorial Work

In addition to residential and commercial carpet cleaning, do you do any janitorial work on the side?
View Results Poll Archive


The Carpet Cleaner's Book of Unlimited Success! (ebook)

Don’t worry about the recession or about your competition.  Now you can be the owner of over 400 ways for carpet cleaning professionals to make more money and get more jobs!

More Products


Director_Buyer.jpgThe premier resource and reference guide for the cleaning and restoration industries.

Click here to view


facebook_40.png twitter_40px.png youtube_40px.png


Truckmount.jpgEquipment listings and specifications from the leading industry manufacturers.

Click here to view